Sugentech Inclix Troponin I Test Kit

• INCLIX™ Troponin I quantitatively measures troponin I concentration in whole blood, serum or plasma. using the INCLIX™ analyzer. For in vitro diagnostic use only.
• Cardiac troponin I (Tn I) is a protein found in myocardial muscle and the most sensitive biomarker for detection of acute myocardial infarction (AMI).The concentration of Tn I in the healthy human is below about 0.5 ng/ml and the level of Tn I is increased within 4-6 hours after the onset of chest pain. After cardiac injury occurs, peak in approximately 8 to 28 hours, and remain elevated for 3 to 10 days following AMI. The Tn I test is well known to be an important prognostic indicator of heart disease.
• The Tn I Test is based on immunochromatography technology. When the sample is loaded to the device, the detection antibody which is conjugated with the colloidal gold in the dried pad binds to Tn I and flows through the membrane. The detection antibody-gold conjugate and Tn I move to the test line area and are accumulated by the capture antibody immobilized on the membrane. This leads to the generation of a reddish colored band. The intensity of the band depends on quantity of Tn I molecules and is analyzed by INCLIX™ analyzer for quantitative readout

• Auto zero function: Manual blanking not required
• Dual wavelength measurement system:
• 2 wave lengths 455nm and 575nm
• Plays major role to remove the interference caused due to Hemolysis & turbidity of sample
• LED Light source:
• LED does not require replacement as it lasts longer
• As compared to Lamp, LED are more suitable as there is no intensity fluctuations
• No warm up time required.
• Flexible unit selection:
• Two units either mg/dl or umol/L are selectable, ease of reporting
• Compact slot for Capillary:
• Accuracy of results are directly related to proper alignment of Capillary
• B-111 has the easiest mode to ensure precise values
• Data transfer:
• External device can be connected to instrument through RS232 por
• USB port

• Light source - LED
• Wavelength - 455nm and 575nm
• Net weight - 1kg
• Measuring range - 0-30 mg/dl , 510 umol/L
• Display - 16×2 LCD module with backlight
• Auto calibration - Yes
• Sample type - Serum or plasma
• Sample volume - 40-80μL
• Test time - <5sec
• Units - mg/dl or umol/L
• Dimensions - 150 (W) × 115 (H) × 190 (D) mm
• Interface - RS232
• Reading cuvette - Heparinized micro capillary holder
• Storage temperature - 15-40°c
• Power supply - DC 9V(DC adapter)
• Power consumption - <2W

• Speed: 11,800rpm with 24- place rotor
• RCF: 14,000g with 24-place rotor
• Acceleration: 0-11,800rpm in 60 seconds, with 24-place rotor
• Brake: Automatic
• Noise: 62dB running with 24-place rotor
• Motor: High precision AC/DC series wound motor, brush gear, computer wound coil winding, balance armature and high speed bearings.
• Timer: 0-15 minute timer, graduated in 1 minute increments. Automatic switch at zero
• Weight: 5.1Kg net (without rotor)
• Dimensions: 23.5cm height x 27cm diameter, footprint 16cm diameter
• Construction: Aluminium casing with a steel lid
• Finish: Body cream white baked enamel, with matt black baked enamel lid

Click Here To Download Catalogue

• Indicator light indicates working state.
• For 4~6 minutes rapidly sterilizing.
• Sterilizing temperature and time can be preset.
• Steam-water inner circulation system: no steam discharge, and the environment for sterilizing will be clean and dry.
• Over temperature & over pressure auto-protection.
• Safe protection of water lacking.
• Exhaust the cool air automatically.
• With three stainless steel sterilizing plates.
• The chamber of the sterilizer is made of stainless steel.
• Automatically shut off with beep reminding after sterilization.

• Results in 20 Seconds

• 100µL sample drawn directly from primary EDTA tube

• Fully automated, walk-away operation

• Random access

• Positive patient identification via internal barcode reader

• Compatible with pediatric tube